|Fuel Line Filter|
Of course, the inside of my gas tank is rusty and it sitting at the painter's for over a month sure didn't help. I know I've got to treat that tank, but it seems no one sells the solution I'm looking for in South Texas (it's a water soluble thing called Evaporust). Well, it finally dawned on me that I should just put in a pair of small and inexpensive fuel line filters. I picked up two of the smallest I could find at Autozone for $4.99 each, cut the fuel line, and popped them in. Took less than five minutes. My brother said he did the same thing years ago with his Honda CBX (six cylinder) and said that after the filter clogged the bike stalled on him on some lonely highway. He just punched a hole in the filter with a screw driver and kept on riding.
We left Saturday morning for a breakfast run to San Isidrio, Texas. Those fuel line filters worked like a charm. About 35 miles down the highway I opened up the throttle a bit and went from a pedestrian 65mph to 85.3mph according to my Garmin GPS. I know it's accurate because it's been certified by radar in the Texas Hill Country. According to the local Sheriff in Camp Wood he said he clocked me at 65mph in a 55mph zone and I had my cruise control set right at 65mph, on the Garmin not on the speedometer.
The bike ran great, smooth and once it warmed up it shifted smoother and just ran better. It idled perfectly at 1,100rpm and should do much better once I get the carbs tuned. Of course, the bike feels much taller and nimbler than my Harley Ultra Classic. I did notice a little wavy (loose) feeling in the rear section as I held the bike at 85mph. I'm not sure if that was because of the wind or some mechanical issue. At 75mph it was totally smooth; at 65mph it was smoother, very quiet, and felt like it could stay at that speed forever.
Once I got home the only noticeable problem was some gear oil weeping from the gear shifter shaft entering the transmission. Maybe that's due to my replacing all the fluids with synthetic oils and perhaps I should go back to the old dino oils. I'm ordering the new seal and that should take care of that problem. I also felt that the saddle just wouldn't do on a day-long ride so I may look at getting a Corbin saddle to replace the custom job on there now.
Conclusion: Yes, I'm very happy with the bike and just want to keep tinkering with it.